Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 52)

Test Interface
Displays port's test information.
Note - The current firmware version does not allow the Test Set Type parameter to
be configured. Attempting to configure this parameter to any valid value will result in
the error "The error occurred with 'Set' operation. Error. bad value.".
Error Statistics
Note - The Ethernet Chip Set parameter is not applicable to the AT-8000GS series
and should be ignored.
Note - The current firmware version returns a 'noSuchName' value for the following
parameters:
ƒ Alignment Error Frames
ƒ Multi Collision Frames
ƒ SQE Test Errors
ƒ Deferred Transmissions
ƒ Carrier Sense Errors
ƒ Symbol Errors
Detail Info
Displays detailed port information such as duplex mode.
Note - The Physical Address Type parameter is not applicable to the AT-8000GS
series and should be ignored.
Note - The current firmware version does not allow the following parameters to be
configured:
ƒ Tagged Mode
ƒ Default Priority
ƒ Row Status
ƒ Port Flow Control Config
ƒ
Port Speed
ƒ Reactive and Combo Ethernet Config
Attempting to configure these parameters to any valid value will result in the error
"The error occurred with 'Set' operation. Error. bad value." except for the Default
Priority parameter.
Note - The current firmware version does not allow the Host Mode parameter to be
set to 'multiple-auth' as its value.
Note - The current firmware version does not allow the Autonegotiation Capabilities
Config parameter to be configured. Attempting to configure this parameter to any
AlliedView™-EMS 4.0.1 Device Management Guide Page 52 of 411