Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 157)

Note - Please refer to Uplink Modules for the operations and behavior of the uplink
modules installed on these devices.
Note - To turn RPS monitoring on or off on the switch, enter the command SET SYSTEM
RPSMONITOR={ON|OFF} from the command line interface. To see whether RPS
monitoring is on, use the command SHOW SYSTEM. To turn on RPS monitoring using
SNMP, set the fanAndPsRpsMonitoringStatus variable to on.
Note - The current firmware version does not allow Device Manager to support the Reset
button.
Note - The current firmware version does not allow Device Manager to support the RPS
LED on the DC models.
Agent Menu
From the Agent menu, you can view and edit the system information for the switch, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Power Supply Info
Displays information about the power supply, redundant power supply and power
supply monitoring. (AC models only)
File List
Displays a list of the files in the switch's flash file system.
Config File Name
Displays the file name of the start-up configuration file.
Telnet
Starts a Telnet connection to the switch.
WEB Browser
Opens your web browser and connects to the switch's HTTP server.
Note - The web browser can only contact the device if the device has a valid
resource file loaded and set, and the HTTP server and GUI on the device are
enabled.
AlliedView™-EMS 4.0.1 Device Management Guide Page 157 of 411