Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 319)

Note - The Counter Discontinuity Time parameter is not applicable to the AT-x900-
12X series and should be ignored.
Note - Valid MIB Set values for the Port Alias parameter is up to 64 characters.
Attempting to enter values greater than the valid range will be accepted but values
exceeding 64 characters will be truncated.
Error Statistics
Displays error statistics.
Note - The Ethernet Chipset parameter is not applicable to the AT-x900-12X series
and should be ignored.
Received Address
Displays the address for which the system will accept packets/frames on the
particular interface.
Note - The Received Address parameter is not applicable to the AT-x900-12X series
and should be ignored
Note - The Received Address Status and Received Address Type parameters are
implemented as 'read-only'.
Spanning Tree Info
Standard
Displays the port's spanning tree parameters.
Note - Valid MIB Set values for the Port Path Cost parameter is in the range [1-
65535] inclusive.
Note - The current firmware version does not allow the Port parameter to be
configured.
Additional Info
Displays additional information on the port's spanning tree parameters.
Note - The current firmware version does not allow the Protocol Migration
parameter to be set to 'true'.
Note - The current firmware version does not allow the Point-to-Point Config
parameter to be set to 'auto'.
Note - Valid MIB Set values for the Port Path Cost Config parameter is [1-
200000000] inclusive. However, the current firmware version allows the user to set
this parameter to '0' as its value and will automatically set the entered value to valid
values.
AlliedView™-EMS 4.0.1 Device Management Guide Page 319 of 411