Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 261)

Scope Boundary Info
Displays a list of the device's scoped multicast address boundaries.
Note - The Scope Boundary Info sub-menu option does not display the correct
parameters. Instead, it displays the sub-menu option name as a parameter with a
value of 'noSuchName'.
Route Table
Displays the table containing multicast routing information for IP datagrams sent by
particular sources to the IP multicast groups known to this device.
Note - The Route Table sub-menu option does not display the correct parameters.
Instead, it displays the sub-menu option name as a parameter with a value of
'noSuchName'.
Next Hop Table
Displays the table containing information on the next hops on outgoing interfaces
for routing IP multicast datagrams.
Note - The Next Hop Table sub-menu option does not display the correct
parameters. Instead, it displays the sub-menu option name as a parameter with a
value of 'noSuchName'.
BOOTP Relay
Basic Info
Displays basic information about the BOOTP relay function.
Note - Valid MIB set values for the Hop Count parameter are in the range [0-16]
inclusive.
Interface Info
Displays information about a specific IP address as a destination to forward BOOTP
packets to.
DNS Relay
Basic Info
Displays basic information about the DNS relay function.
Interface Info
Displays the current DNS relay static.
MD5 Key Config
Displays the current MD5 key table.
Note - To configure the MD5 Key parameter, the Row Status parameter must first
be set to 'create and go'. Once the MD5 Key parameter has been configured, the
Row Status parameter is automatically set to 'active'.
AlliedView™-EMS 4.0.1 Device Management Guide Page 261 of 411