Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 376)

Note - AT-CV5M01: The current firmware version does not allow Device Manager
to display the TX port values configured via Telnet.
Note - AT-CV5M01: The current firmware version does not allow Port Mode, Port
Duplex Status and Port MDIX parameters to be configured if the current Port Speed
parameter is set to '100Mbps'.
Port Statistics
Displays the basic port statistics configuration information. Options to view all/per
module information are displayed.
Remote Line Card Info
Displays the Remote Line Card information of the AT-CMxx series line cards.
Remote Module Info
Displays the module info of the line cards.
Note - AT-CV5M01: The current firmware version does not allow the Remote Local
Module Name parameter to be configured.
Note - The current firmware version does not allow the Remote Module Name
parameter to be configured.
Note - AT-CV5M01: The current firmware version does not display the Remote
Module Name, Remote Module Type and Remote Module Software Version
parameters correctly.
Note - AT-CV5M01: The current firmware version returns a 'noSuchName' value for
the Remote Module Software Version parameter.
Remote Port Info
Displays the remote port information of the line cards.
Note - AT-CV5M01: The current firmware version returns a 'noSuchName' value for
the Remote Port MDIX and Remote Port Flow Control parameters.
Note - AT-CV5M01: The current firmware version does not allow Remote Port
Mode, Remote Port Duplex and Remote Port Speed parameters of TX type of ports
to be configured. Attempting to configure these parameters other than its current
values will result in the error message: "The error occurred with 'Set' operation.
Error: time out occurred."
Note - AT-CV5M01: The current firmware version does not allow Remote Ingress
Rate Limit and Remote Egress Rate Limit parameters to be configured. Attempting
to configure these parameters other than its current values will result in the error
message: "The error occurred with 'Set' operation. Error: time out occurred."
AlliedView™-EMS 4.0.1 Device Management Guide Page 376 of 411