Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 342)

Note - The current firmware version does not allow the Board Bay parameter to be
configured. Attempting to configure this parameter to any valid value will result in
the error "The error occurred with 'Set' operation. Error: gen error".
Firmware Info
Current Firmware
Displays information about the current software version installed in the device.
Note - Configuring the Save Current Software parameter to values greater than its
valid range will be accepted but will cause the device to restart intermittently.
Note - The current firmware version allows the Save Current Software parameter to
be set to a 'null' value. However, the Save Current Software parameter will always
return 'saving (null)' value and will not be configurable unless the switch is restarted.
Note - The SNMP agent may take awhile to respond if the Save Current Software
parameter has been set to 'saving'. When this happens, it may take a while for device
information to be displayed in Device Manager.
Next Boot Firmware
Displays the version of the firmware that the device is currently set to boot from
and its full path.
Backup Firmware
Displays the backup software version and its path in the device.
Software License Info
Base License
Displays information about the installed base software licenses on the device.
Installed Licenses
Displays information about the software licenses installed on the device.
Note - The current firmware version returns inconsistent values for the Index and
Stack ID parameters.
Note - Configuring the Row Status parameter to 'destroy' as its value will result to
an error message "The error occurred with 'Set' operation. Error: time out
occurred". However, the value is still set successfully.
Features Info
Displays information about the feature licenses installed on the device.
Install New License
Allows the user to install a new license on the device.
AlliedView™-EMS 4.0.1 Device Management Guide Page 342 of 411