Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 244)

Additional Info
Displays Bad Frames Received and Collision parameters.
Note - Use SNMP v2c or v3 to view this table.
Detail Info
Displays detailed port information such as duplex mode.
Note - The Port MDIO parameter is not applicable to the AT-9408LC/SP.
Note - The Port CoS/QoS Priority and Port STP State parameters are not applicable
to the AT-9400 series and should be ignored.
Note - Valid MIB Set values for the Port Flow Control and Port Back Pressure
parameters are 'disable' and 'enable'. Attempting to set these parameters to
'unknown' will cause them to be set to 'enable'.
Note - Configuring the Port HOL Limit parameter of a slave switch to any value
within the range [1-8191] will return a Set Error and will cause the master device to
restart.
Note - L3 Models: The current firmware version does not allow the Port Speed and
Port Duplex parameters to be configured to the desired port speed and duplex
mode. As a result, the speed label that will be displayed on the port image and its
corresponding DUP LED will depend on the actual speed and duplex mode detected
by the device.
Note - AT-94xxTs/XP: The current firmware version returns the value 'unknown' for
the Port Speed parameter of the XFP ports.
Enable
Enables the port.
Disable
Disables the port.
Port Trunking
Displays Port Trunking information as returned by the device and allows the
configuration of trunk name, method and port list.
Note - The current firmware version allows the Trunk Name parameter to be
configured.
Note - L3 Models: The current firmware version does not return any Set Error when
configuring the Row Status parameter to 'not in service'.
Note - L3 Models: The current firmware version does not return any Set Error when
configuring the Port List parameter to invalid values.
AlliedView™-EMS 4.0.1 Device Management Guide Page 244 of 411