Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 382)

AlliedView™-EMS 4.0.1 Device Management Guide Page 382 of 411
yet configured.
Note - AT-CV5M01: The current firmware version does not allow the Port Mode
parameter of FX type of ports to be configured. Attempting to configure this parameter
n its current Port Mode value will result in the error message: "noSuchName."
Port Info
rt Mode parameter of a port with an established link
automatically changes to 'auto' when the settings of the port to which it is
d parameter of a port with an established link
automatically changes to '10Mbps' when the value of its Port Mode parameter is
Note - The current firmware version does not allow the Port Ingress Rate Limit and
M01: The current firmware version does not allow Port Speed and
Port Duplex Status parameters to be set to '1Gbps' and 'unknown' values
ctively.
AT-CM70S
other tha
Note - The value of the Po
connected are modified.
Note - The value of the Port Spee
changed from 'auto' to 'manual'.
Port Egress Rate Limit parameters to be configured.
Note - AT-CV5
respe
4 x TI/E1 + 1 TX over SFP-based fiber. 0/100
LED State Description
DUP
Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.