Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 243)

Port Menu
From the Port menu, you can view and edit MIB information about the port.
Utilization
Displays the port's utilization information.
Interface Info
Standard
Displays port statistics such as the number of packets received and transmitted on
the port, bytes received and transmitted on the port and port status. This table also
displays high-capacity port statistics including received and transmitted
unicast/multicast/broadcast packets on the port, link up/down trap and port speed.
Note - Valid MIB Set values for the Administration Status parameter are 'up' and
'down'. Attempting to set this parameter to any other value will result in the error
message: "The error occurred with 'Set' operation. Error: bad value."
Note - The current firmware version does not allow the Port Alias parameter to be
configured.
Note - Use SNMP v2c or v3 to view high capacity (HC) port parameter values.
Note - L3 Models: The current firmware version returns the value 'NULL' for the
Specific Media parameter.
Additional Info
Displays port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port and port status.
Note - Use SNMP v2c or v3 to view this table.
Error Statistics
Displays error statistics.
Standard
Displays port error statistics such as error frames and collision frames. It also
displays deferred transmissions and ethernet chipset information.
Note - When multiple units of the AT-9400 are stacked together, and the master
switch is an AT-9424Ts or an AT-9424Ts/XP, the current firmware version returns
incorrect values for the Error Statistics parameter.
Note - L3 Models: The current firmware version returns the value 'NULL' for the
Ethernet Chip Set parameter.
AlliedView™-EMS 4.0.1 Device Management Guide Page 243 of 411