Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 256)

Note - The current firmware version does not allow the following parameters to be
configured:
ƒ
AS Border Router Status
ƒ Type of Service Support Status
ƒ Ext Link State DB Limit
ƒ Multicast Extensions
ƒ Exit Overflow Interval
ƒ Demand Extensions
Area Info
Displays the configured parameters and cumulative statistics of the device's attached
areas.
Note - The Authentication Type parameter is not applicable to the AT-9700 Series
and should be ignored.
Stub Area Config
Displays the set of metrics that will be advertised by a default Area Border Router
into a stub area.
Note - The current firmware version does not allow the Row Status and Metric Type
parameters to be configured.
Link State Ads
Displays the OSPF Process' Link State Database.
Note - The Link State Ads sub-menu option does not display the correct parameters.
Instead, it displays the sub-menu option name as a parameter with a value of
'noSuchName'.
Host Info
Displays the list of hosts, and their metrics, that the device will advertise as host
routes.
Note - The current firmware version does not allow the Metric parameter to be set
to 0.
Interface Info
Displays the interfaces from the viewpoint of OSPF.
Note - The current firmware version does not allow the following parameters to be
configured:
ƒ Type
ƒ Transit Delay
ƒ Retransmission Interval
ƒ Multicast Forwarding
AlliedView™-EMS 4.0.1 Device Management Guide Page 256 of 411