Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 269)

Server Info
Displays information about servers.
Note - The current firmware version does not allow the Authentication Key
parameter to be configured.
Note - The only valid MIB Set value for the Row Status parameter is ‘destroy’.
Attempting to set this parameter to any other value will result in the error message:
”The error occurred with 'Set' operation. Error: bad value.”
Access Control List
Ethernet Info
Displays ACL mask of Ethernet information.
Note - The current firmware version does not allow the following parameters to be
configured:
ƒ Filtered Ports
ƒ Source MAC Address Mask
ƒ
Destination MAC Address Mask
Ethernet Rule
Displays ACL rule of Ethernet information.
Note - The current firmware version does not allow the following parameters to be
configured:
ƒ VLAN
ƒ Source MAC Address
ƒ Destination MAC Address
ƒ Ethernet Type
IP Info
Displays ACL mask of IP information.
Note - The current firmware version does not allow the following parameters to be
configured:
ƒ Filtered Ports
ƒ TCP/UDP Source Port Mask
ƒ TCP/UDP Destination Port Mask
ƒ Protocol ID Mask
IP Rule
Displays ACL rule of IP information.
Note - The current firmware version does not allow the VLAN and User Mask
parameters to be configured.
AlliedView™-EMS 4.0.1 Device Management Guide Page 269 of 411