Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 59)

Device Manager LEDs for AT-8000S Series
LED State Description
PWR Green The switch is receiving power.
STACK ID Orange
Gray
Green
The stacked unit is either the Stacking Master or the Backup
Master.
The switch is a set to standalone mode.
The stacked unit is a slave switch.
DUPLEX Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
Note - When multiple units of the AT-8000S series are stacked together, port numbering is
continuous based on the Box ID.
• Box ID 1 - 1 to 54
• Box ID 2 - 55 to 108
• Box ID 3 - 109 to 162
• Box ID 4 - 163 to 216
• Box ID 5 - 217 to 270
• Box ID 6 - 271 to 324
This numbering scheme assumes that a unit can have a maximum of 54 ports.
Combo ports on the AT-8000S/24 and AT-8000S/24POE devices are assigned port
numbers 49 and 50.
Note - The current firmware version does not allow Device Manager to detect the presence
of an SFP module in any of the SFP slots unless there is an active connection on the SFP
ports. As a result, SFP images will appear on the device panel only if there is an established
connection on the physical SFP ports.
Agent Menu
From the Agent menu, you can view and edit the system information for the device, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Note - The current firmware version accepts up to 160 characters for the System
Name parameter.
AlliedView™-EMS 4.0.1 Device Management Guide Page 59 of 411