Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 391)

Note - The current firmware version does not allow the Port Ingress Rate Limit
and Port Egress Rate Limit parameters to be configured. Attempting to set these
parameters to valid values will result in the error message: " The error occurred
with 'Set' operation. Error: bad value.".
Module Info
Displays the Linecard's port information.
Note - The current firmware version has irregular GETNEXT behavior. As a result,
Device Manager will display Module Info parameters in a single column table instead
of displaying it per port or per interface.
Note - The Module Location parameter always displays the value ????(N)?.
Note - The current firmware version does not allow the Port Ingress Rate Limit and
Port Egress Rate Limit parameters to be configured. Attempting to set these
parameters to valid values will result in the error message: " The error occurred
with 'Set' operation. Error: bad value.".
Port Interface Info
Displays the basic port interface configuration information. Options to view
all/module 1/module 2 information are displayed.
Note - The current firmware version does not return the correct value of the Port
Name parameter when configured. Attempting to check this parameter in CLI will
show that the parameter was successfully set.
Note - The Module Location parameter always displays the value '???(N)'.
Note - Valid MIB Set values for the Port Operation Mode parameter are "smart
missing link", "missing link" and "link test". However, the current firmware version
allows the Port Operation Mode parameter to be set to "oam bypass" or "oam
visible".
Note - The current firmware version returns inconsistent values on the Port
Operation Mode parameter.
AT-MCF2000 Media Converter
AlliedView™-EMS 4.0.1 Device Management Guide Page 391 of 411