Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 299)

ƒ Next Hop AS Number
ƒ Destination Metric 1
ƒ Destination Metric 2
ƒ Destination Metric 3
ƒ
Destination Metric 4
ƒ Destination Metric 5
ƒ Row Status
IP Statistics
Displays statistics about IP, such as the number of IP datagrams received.
Note - Valid MIB Set values for the Default TTL parameter should range from 1-255.
However, the current firmware version does not allow this parameter to be set to
'1' as its value. Attempting to set this parameter to '1' will result in the error
message "The error occurred with 'Set' operation: time out occurred." Connection
with the device will be lost and the only way to re-establish connection will be to
perform a manual reset.
Note - Setting the Forwarding Status parameter to 'not forwarding' will not return an
error message but connection with the device will be lost. The only way to re-
establish connection will be to perform a manual reset.
UDP
Listener Info
Displays UDP listener information.
UDP Statistics
Displays UDP statistics.
TCP
Connection Info
Displays TCP connection-specific information.
Note - The Connection Status parameter is implemented as 'read-only'.
TCP Statistics
Displays TCP statistics.
ICMP Statistics
Displays ICMP statistics.
DNS
DNS Server
Displays DNS server information.
Note - The current firmware version does not allow the Status parameter to be set
to 'active' as its value. Attempting do so will result in the error message "The error
occurred with 'Set' operation. Error: time out occurred".
AlliedView™-EMS 4.0.1 Device Management Guide Page 299 of 411