Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 367)

ƒ Received Bytes (HC)
ƒ Received Unicast Packets (HC)
ƒ Received Multicast Packets (HC)
ƒ Received Broadcast Packets (HC)
ƒ
Transmitted Bytes (HC)
ƒ Transmitted Unicast Packets (HC)
ƒ Transmitted Multicast Packets (HC)
ƒ Transmitted Broadcast Packets (HC)
Note - The Promiscuous Mode parameter is implemented as 'read-only'.
Note - The Counter Discontinuity Time parameter is not applicable to the
SwitchBlade x908 series and should be ignored.
Note - Valid MIB Set values for the Port Alias parameter is up to 64 characters.
Attempting to enter values greater than the valid range will be accepted but values
exceeding 64 characters will be truncated.
Error Statistics
Displays error statistics.
Note - The Ethernet Chipset parameter is not applicable to the SwitchBlade x908
series and should be ignored.
Received Address
Displays the address for which the system will accept packets/frames on the
particular interface.
Note - The Received Address parameter is not applicable to the SwitchBlade x908
series and should be ignored.
Note - The Received Address Status and Received Address Type parameters are
implemented as 'read-only'.
Spanning Tree Info
Standard
Displays the port's spanning tree parameters.
Note - Valid MIB Set values for the Port Path Cost parameter is in the range [1-
65535] inclusive.
Note - The current firmware version does not allow the Port parameter to be
configured.
Additional Info
Displays additional information on the port's spanning tree parameters.
AlliedView™-EMS 4.0.1 Device Management Guide Page 367 of 411