Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 42)

TFTP
Displays configuration information about the TFTP.
Note - The current firmware version does not allow the Send Config File parameter
to be configured.
Note - Configuring the Get Config File parameter will cause the device to reboot and
reset its running configuration to default configuration.
Note - The current firmware version does not allow the File Server IP Address
parameter to be configured.
Note - Configuring the Retry Timeout and Total Timeout parameters to invalid
values will automatically set the entered values to valid values.
UDP
Listener Info
Displays User Datagram Protocol listener information.
UDP Statistics
Displays User Datagram Protocol statistics.
TCP
Connection Info
Displays Transmission Control Protocol connection-specific information.
Note - The current firmware version does not allow Connection Status parameter
to be configured. Attempting to configure this parameter to any valid value will
result in the error "The error occurred with 'Set' operation. Error: gen Error.".
TCP Statistics
Displays Transmission Control Protocol statistics.
CIDR
Route Number
Displays the number of valid Classless Inter-Domain Routing entries.
Route Table
Displays the Classless Inter-Domain Routing routing tables.
Note - The current firmware version does not allow Routing Type parameter to be
configured. Attempting to configure this parameter to any valid value will result in
the error "The error occurred with 'Set' operation. Error. bad value.".
Note - The current firmware version does not allow the following parameters to be
configured:
ƒ Destination Port Number
AlliedView™-EMS 4.0.1 Device Management Guide Page 42 of 411