Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 43)

ƒ Routing Protocol MIB
ƒ Destination Metric 2
ƒ Destination Metric 3
ƒ Destination Metric 4
ƒ
Destination Metric 5
Note - The current firmware version only allows the Routing Type parameter to be
set to 'reject' if the value prior to set operation is 'remote'.
ICMP
ICMP Statistics
Displays Internet Control Message Protocol Statistics.
Error Messages
Displays the variable that controls the ability to generate Internet Control Message
Protocol error messages.
DHCP Info
Basic Info
Displays DHCP information.
Snooping
Displays the system's DHCP Snoop information.
Note - The current firmware version does not allow the Clear Action parameter to
be set to 'noAction' as its value.
DNS Resolver
Resolver Config
Displays information about the Domain Name System client.
Note - The current firmware version does not allow the Reset parameter to be
configured to 'reset' as its value. Attempting to configure this parameter to any valid
value will result in the error "The error occurred with 'Set' operation. Error. bad
value.".
Basic Counters
Displays information about basic Domain Name System couters.
Counters by OpCode
Displays information about the current count of resolver queries and answers.
Counters by Response Code
Displays information about the current count of responses to resolver queries.
Lame Delegation Overflows
Displays information about number of times the resolver attempted to add an entry
to the lame delegation table.
AlliedView™-EMS 4.0.1 Device Management Guide Page 43 of 411