Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 219)

Note - Although the current firmware allows the Administration Status parameter to
be set to 'testing', the value 'testing' is not a valid MIB Set value.
Note - The Promiscuous Mode parameter is implemented as 'read-only'.
Detail Info
Duplex Mode
Displays the duplex mode of the ports.
Bandwith Limits
Displays bandwidth limits of the switch ports.
Error Statistics
Displays error statistics.
Note - The following parameters are not applicable to AT-Rapier48w and should be
ignored:
ƒ Ethernet Chip Set
ƒ Symbol Errors
ƒ Duplex Status
Spanning Tree Info
Displays the port's spanning tree parameters.
MAU Info
Displays interface-related MAU information for the port.
Note - The MAU Type List Bits and HC False Carriers parameters are not applicable
to the AT-Rapier48w and should be ignored.
Note - The MAU Status and Default MAU Type parameters are implemented as
'read-only'.
MAU Negotiation Info
Displays the MAU's auto-negotiation settings and its status.
Note - The following parameters are not applicable to the AT-Rapier48w and should
be ignored:
ƒ Capability Bits
ƒ Advertised Bits
ƒ Received Bits
ƒ Remote Fault Advertised
ƒ Remote Fault Received
Note - The Administration Status, Advertised Negotiation Capability and Restart
parameters are implemented as 'read-only'.
AlliedView™-EMS 4.0.1 Device Management Guide Page 219 of 411