Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 36)

Mid-level Management
Alarm Options
Displays information about alarm options.
Note - The current firmware version does not allow Alarm Enabling
parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation.
Error: noSuchName.".
Note - The current firmware version does not allow Row Status parameter
to be configured. Attempting to configure this parameter to any valid value
will result in the error "The error occurred with 'Set' operation. Error: gen
Error.".
MIB Tree
Displays information about the device's MIB tree.
Tuning
Agent Diagnostics
Displays diagnostic information about the agent.
Note - The Location parameter is not applicable to the AT-8000GS series
and should be ignored.
General Tuning
Displays general tuning information.
Note - Valid MIB Set values for the Debug Level parameter should range from
1-100. However, the current firmware version allows the user to enter
values in the range 0-255.
Note - The current firmware version returns inconsistent values when
configuring High Priority and Low Priority parameters.
Max Entries Tuning
Displays information about the maximum entries in tuning.
TCP Tuning
Displays the memory pool size for Transmission Control Protocol tuning.
Radius Tuning
Displays the memory pool size for radius tuning.
Syslog Tuning
Displays the current cache size and its size after reset.
Management ACL Tuning
Displays the current number of access rules and the number after reset.
AlliedView™-EMS 4.0.1 Device Management Guide Page 36 of 411