Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 41)

Note - The current firmware version does not allow Mapping Type parameter to be
set to 'invalid' or 'other' as its value.
Address Table
Standard
Displays the list of IP interfaces on the switch.
Additional Info
Displays additional information about the address table.
Note - The Backup Address parameter is not applicable to the AT-8000GS
series and should be ignored.
Note - The current firmware version does not allow the IP Interface Owner
parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation.
Error. bad value.".
Note - Configuring the Port Number parameter will cause the device to be
inaccessible and may need the restarted.
Static Route Table
Displays the IP static routing table.
Note - The current firmware version does not allow Routing Type parameter to be
set to 'local' as its value.
Note - Configuring the Destination Metric and Next Hop AS Number parameters to
invalid values will automatically set the entered values to valid values.
IP Statistics
Displays statistics about IP routing, including the number of IP datagrams received.
Note - The current firmware version does not allow Forwarding Status parameter to
be configured. Attempting to configure this parameter to any valid value will result in
the error "The error occurred with 'Set' operation. Error. bad value.".
ARP Table Config
Displays configuration information about Address Resolution Protocol.
Note - The current firmware version does not allow Unresolve Timer parameter to
be configured. Attempting to configure this parameter to any valid value will result in
the error "The error occurred with 'Set' operation. Error. bad value.".
I/F Name-Address Translation
Displays information about the IP interface's name translated to an IP interface
address.
AlliedView™-EMS 4.0.1 Device Management Guide Page 41 of 411