Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 388)

AlliedView™-EMS 4.0.1 Device Management Guide Page 388 of 411
Device Manager LEDs for AT-MCF2000 Chassis
LED State Description
Gray Power supply 2 is not installed or it is installed but not powered
on.
FAN Green
Gray
FAN is installed and power is on.
FAN is not installed or it is installed but not powered on.
Note - Please refer to AT-MCF2000 Modules for the operation and behavior of the modules
installed on the chassis.
Note - While the Reset Chassis operation is in progress, error "The error occurred with
'Set' operation. Error: time out occurred." will be displayed and port image of the line card
(if inserted) will appear red and should be ignored.
Agent Menu
From the Agent Menu, you can view and edit the system information for the chassis, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Note - Valid MIB Set values for the System Name, System Contact and System
Location parameters are in the range [0-25] inclusive. However, the current
firmware version accepts inputs of up to 40 characters.
Device Info
Displays device-related information such as the software version and bootloader
version of the modules.
Chassis Info
Displays chassis information, including MAC Address and Serial Number.
Management Module Info
Displays Management Module's information, including software and bootloader
versions.
Note - The Module Location parameter always displays the value '???(N)'.
Note - The current firmware version is unable to display values for the following
parameters when the Management Module Chassis ID is set to 31: