Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 375)

Diagnostics
Displays the device's software version, fan speed and fan temperature.
Reset
Resets the device.
Telnet
Starts a Telnet connection to the chassis.
The following submenu option will only be available when AT-CV5M02 Management
module is installed:
WEB Browser
Starts a WEB browser session to the chassis.
Status Menu
From the Status Menu, you can view information about Converteon Series Modules
installed on the chassis.
Module Info
Displays the basic module configuration information of the device. Options to view
all/per module information are displayed.
Note - The Module Name parameter serves as the slot name. As such, any value
specified for this parameter will be retained even if the line card occupying the slot is
removed or replaced.
Note - Setting the Module Reset parameter of media converter line cards to 'yes' will
not reset the line cards.
Note - The Module Reset parameter always displays the value '???(0)'.
Note - The Module Operation Mode parameter of CPMs always displays '???(0)'.
Note - AT-CV5M01: The current firmware version does not allow the Module Name
parameter to be configured.
Port Info
Displays the port cofigurable parameters. Options to view all/per module
information are displayed.
Note - AT-CV5M01: The current firmware version returns a 'noSuchName' value for
the Port Flow Control parameter.
Note - AT-CV5M01: The value of the Port Mode and Port Duplex Status parameters
automatically changes to 'manual' and 'half duplex' respectively when the value of its
Port Speed parameter is changed from '100Mbps' to '10Mbps'.
AlliedView™-EMS 4.0.1 Device Management Guide Page 375 of 411