Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 152)

Traffic Classes
Displays Traffic Class parameters used to provide most of the QoS controls.
Note - The current firmware version accepts up to 32 characters for the Description
parameter. NULL values are not allowed.
Policies
Displays Policy parameters.
Note - The current firmware version accepts up to 32 characters for the Description
parameter. NULL values are not allowed.
Note - The Redirect Port parameter is cleared of its value each time the switch is
restarted.
Note - The current firmware version does not allow the Ingress Port List and Egress
Port List parameters to be set to NULL.
Enable
Enables the port.
Disable
Disables the port.
Port Mirroring
Displays Port Mirroring parameters and allows you to create/delete a port mirror.
Note - The Mirroring Source Module, Mirroring Source Port and Mirroring
Destination Module parameters are not applicable to the AT-8500 series and should
be ignored.
Note - Setting the Port Mirroring Status parameter to 'enabled' without setting the
Mirroring Destination Port parameter to a valid value first will result in the error
message "The error occurred with 'Set' operation. Error: gen Error". However, the
value 'enabled' is still set successfully.
Note - The current firmware version does not allow the Mirroring Destination Port
parameter to be set to 0.
Note - The current firmware version does not allow the Mirroring Source Port
(Ingress) and Mirroring Source Port (Egress) parameters to be set to NULL.
Note - The current firmware version does not allow the Port Mirroring Status
parameter to be set to 'enabled' if, upon device startup, the Port Mirroring feature is
disabled.
AlliedView™-EMS 4.0.1 Device Management Guide Page 152 of 411