Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 390)

Note - Valid MIB Set values for the System Name, System Contact and System
Location parameters are in the range [0-25] inclusive. However, the current
firmware version accepts inputs of up to 40 characters.
System Date and Time
Displays the system's Date, Time and Network Time Protocol configuration.
Note - Configuring the NTP Mode parameter to "Enable" will result in the error
message: "The error occurred with 'Set' operation. Error: time out occurred." but
the NTP Mode will still be successfully set.
Note - Configuring the NTP Server parameter will result in the error message: "The
error occurred with 'Set' operation. Error: time out occurred." but the NTP Server
address will still be successfully set.
System Log
Displays the system's log information.
Reset
Resets the chassis and/or modules.
Telnet
Starts a Telnet connection to the chassis.
Status Menu
From the Status Menu, you can view information about AT-MCF2000 Modules installed on
the chassis.
Port Info
Displays the port cofigurable parameters. Options to view all/module 1/module 2
information are displayed including the configurable parameters for the management
port.
Management Port Info
Displays the Management Module's port information.
Note - Configuring the following parameters to any valid value will result in the error
message: "The error occurred with 'Set' operation. Error: time out occurred." but
values will still be successfully set.
ƒ Management Port Auto Negotiation
ƒ Management Port Speed
ƒ Management Port MDIX
AlliedView™-EMS 4.0.1 Device Management Guide Page 390 of 411