Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 273)

QoS
Basic Config
Displays QoS parameters and allows enabling of Hol prevention status and setting of
scheduling mechanism.
Scheduling Mechanism
Displays scheduling mechanism parameters.
802.1p Default Priority
Displays the 802.1p default priority table..
802.1p User Priority
Displays the 802.1p user priority class table.
User Priority Regeneration
Displays the regenerated user priorities table.
Traffic Class
Displays the traffic class table.
Outbound Access Priority
Displays the outbound access priority table.
Bandwidth Control
Displays the bandwidth control table.
Note - Valid MIB Set values for the Receive Rate and Transmit Rate parameters are
in the range [1-10000] inclusive. However, specifying a value greater than 999 will
automatically set these parameters to 999.
Port Trunking
Basic Info
Displays basic information about port trunking.
Trunk Config
Displays port trunking parameteres and allows configuration of the master port,
member ports, trunk type and trunk status.
Note - The current firmware version does not allow the Member Ports and Trunk
Type parameters to be configured.
Aggregator Info
Displays information about every Aggregator that is associated with this system.
Note - The current firmware version returns 'noSuchName' for the Aggregate Index
parameter.
AlliedView™-EMS 4.0.1 Device Management Guide Page 273 of 411