Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 109)

Event Table
Displays the RMON Event table.
Event Log
Displays the RMON Event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Utilization
Displays the port's utilization information.
Interface Info
Displays port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port, and port status.
Note - Valid MIB Set values for the Administration Status parameter are 'up' and
'down'. Attempting to set this parameter to any other value will result in the error
message: "The error occurred with 'Set' operation. Error: gen Error."
Error Statistics
Displays error statistics.
Detail Info
Displays detailed port information such as duplex mode.
Note - The Port Name parameter is not applicable to the AT-9410GB.
Note - The current firmware version does not allow the Port VLAN Tag Priority
parameter to be configured. Attempting to configure this parameter will result in the
error message: "The error occurred with 'Set' operation. Error: bad value."
Note - The Port Transmit Pacing Configuration parameter is not applicable to the
AT-9410GB.
Note - Device Manager allows the user to disable an active port. However, the
disabled port's Port Link State parameter retains the value 'on-line'.
Note - When connection is established between a twisted pair port that is
configured to auto-negotiate and a port on another device that is configured to
operate at 10/100Mbps full/half duplex, expect the link to drop when the twisted
pair port's speed and mode is changed to match the speed and mode of the port on
the other device.
AlliedView™-EMS 4.0.1 Device Management Guide Page 109 of 411