Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 33)

AlliedView™-EMS 4.0.1 Device Management Guide Page 33 of 411
Device Manager LEDs for AT-8000GS Series
DUPLEX Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
Note - When multiple units of the AT-8000GS series are stacked together, port numbering
is continuous based on the Stack Number.
• Stack 1 - 1 to 50
• Stack 2 - 51 to 100
• Stack 3 - 101 to 150
• Stack 4 - 151 to 200
• Stack 5 - 201 to 250
• Stack 6 - 251 to 300
This numbering scheme assumes that a unit can have a maximum of 50 ports.
Note - The current firmware version does not allow Device Manager to detect the presence
of an SFP module in any of the SFP slots unless there is an active connection on the SFP
ports. As a result, SFP images will appear on the device panel only if there is an established
connection on the physical SFP ports.
Note - The current firmware version does not allow Device Manager to handle redundant
ports. As a result, the Duplex LED of the copper ports will remain green even if there is an
established connection on the equivalent SFP ports.
Agent Menu
From the Agent menu, you can view and edit the system information for the device, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Note - Valid MIB Set values for the System Name parameter is up to 160 characters.
Note - The current firmware version allows the user to set System Name parameter
to NULL.
Device Info
General Info
Displays common management information.
Active Software File
Displays the currently available images on the flash.