Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 348)

Note - The current firmware version does not allow the Status parameter to be set
to 'active' as its value. Attempting do so will result in the error message "The error
occurred with 'Set' operation. Error: time out occurred".
DNS Client
Displays DNS Client information.
Bridge Menu
From the Bridge menu, you can view and edit bridge information such as the forwarding
database and the spanning tree status.
Forwarding Database
Standard View
Displays the Forwarding Database table as returned by the device.
Note - The current firmware version returns the value "00 00 CD 00 00 00" for the
Management MAC Address parameter of base port 11.
Enhanced View
Displays the Forwarding Database table on a per port basis. User can select a port
or group of ports to view its corresponding Forwarding Database entries.
Discard/Aging Time Info
Displays information about the number of address entries that were learned but
discarded for reasons such as lack of memory or the entry's aging timer.
Note - Valid MIB Set values for the Aging Time parameter is in the range [10-630]
inclusive.
Note - Values entered for the Aging Time parameter must be multiples of 10. Values
that are not multiples of 10 will be automatically rounded down to the nearest tens.
Spanning Tree Info
Displays spanning tree parameters such as priority and cost.
Statistics
Displays statistics about frames received/transmitted on the switch port.
Basic Bridge Info
Displays basic bridge information.
Bridge Port Info
Displays bridge port information.
Note - The current firmware version returns the value 'NULL' for the Circuit
parameter.
AlliedView™-EMS 4.0.1 Device Management Guide Page 348 of 411