Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 39)

Note - The current firmware version does not allow DST Start and DST End
parameters to be configured when the DST Mode is set to 'recurring' or 'date' value.
Note - The current firmware version does not allow Device Manager to display the
Managed Time parameter in a 12hour format.
Note - Valid MIB Set values for the Time Zone Code and DST Code parameters are
up to 4 characters. However, the current firmware version allows the user to enter
up to 16 characters.
SNTP/NTP Client Config
Displays information about SNTP/NTP client configuration.
Note - Valid MIB Set values for the Polling Interval parameter should range from 60-
86400. However, the current firmware version allows the user to enter values
outside of the valid range and negative values as well.
SNTP Config
Displays information about SNTP client configuration.
Broadcast Mode
Displays information about broadcast mode per interface.
SNTP Server Info
Displays information about trusted SNTP servers to be queried in unicast or
broadcast mode.
Note - Valid MIB Set values for the Key Identifier parameter is [1-4294967295]
inclusive. However, the current firmware version allows the user to enter the value
'0'.
Authentication Keys
Displays information about keys information for authentication of NTP packets.
Note - The Key ID parameter is implemented as 'read-only'.
System Log
Basic Info
Displays information and configuration of the device's log files.
Note - The current firmware version does not allow Clear Log File and Clear Cache
parameters to be configured.
Event Log
Displays information about events sent to the system log file.
AlliedView™-EMS 4.0.1 Device Management Guide Page 39 of 411