Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 360)

Stack ID and Destination Stack ID parameters are incorrect. However, copy,
move or delete operation will not be successful.
SD Card
Displays information about the installed SD cards.
Config File Info
Device Configurations
Current Config
Allows the user to save and set the running configuration of the device to its
flash.
Next Boot Config
Displays the full path of the configuration file to use the next time the device
is rebooted.
Default Config
Displays the default config file info of the device.
GUI Configurations
Displays the latest GUI applet file residing in the root directory of flash that
is applicable to the currently running system software.
CLI Servers
Displays information about CLI Servers.
Users
User Info
Displays the information about the users currently logged in the device.
User Config
Displays the information about the users configured in the local user database of the
device.
NTP
Peers
Displays the NTP Peer Information on the device.
Note - The current firmware version does not allow the Row Status parameter to be
set to 'active' as its value. Attempting to do so will result in the error message "The
error occurred with 'Set' operation. Error: time out occurred".
Note - Valid MIB Set values for the Name Address parameter is from 1 to 256
characters. However, the current firmware version allows the user to enter values
greater than the valid range.
Associations
Displays the NTP Association on the device.
AlliedView™-EMS 4.0.1 Device Management Guide Page 360 of 411