Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 255)

Route Preferences
Displays configurations of routing preferences.
Route Redistribution
Displays the route redistribution table of various protocols.
RIP
Basic Info
Displays basic information about Routing Information Protocol.
Interface Info
Displays the list of subnets which require separate status monitoring in Routing
Information Protocol.
Note - The Row Status parameter has a fixed value of 'active' and cannot be
modified.
Interface Config
Displays the list of subnets which require separate configuration in Routing
Information Protocol.
Note - The current firmware version does not allow the Domain and Default Metric
parameters to be configured.
Note - Valid MIB Set values for the Row Status parameter are 'active' and 'not in
service'. Attempting to set this parameter to any other value will result in the error
message: "The error occurred with 'Set' operation. Error: bad value".
Note - The current firmware version does not allow the following parameters to be
configured:
ƒ Domain
ƒ Authentication Key
ƒ Default Metric
ƒ Source IP Address
Active Peer Info
Displays information about active peer relationships.
OSPF
Basic Info
Displays basic information about Open Shortest Path First routing protocol.
AlliedView™-EMS 4.0.1 Device Management Guide Page 255 of 411