Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 246)

Note - L3 Models: The current firmware version does not allow the Attack Action
Status parameter to be set to 'enabled'.
Note - L3 Models: The current firmware version does not allow the Attack Mirror
Port Status parameter to be set to 'enabled' or 'disabled'.
Teardrop Config
Displays teardrop attack type configuration
Ping Death Config
Displays ping of death attack type configuration
Stacking Menu
From the Stacking menu, you can veiw physical stack info and you can access slave switches
and other Master switches in the enhanced stack.
Stack Info
Displays the number of modules present in the stack.
Enhanced Stacking Info
Displays Enhanced Stacking parameters, allows you to set the switch's enhanced
stacking status and select a switch to manage in the enhanced stack.
Note - Attempting to connect to an AT-9424Ts or an AT-9424Ts/XP slave from any
master device that supports Enhanced Stacking will result in the error message: "The
error occurred with 'Set' operation. Error: gen Error".
Note - Attempting to connect to an AT-8400 slave from an AT-9400 master will
result in the error message: "The error occurred with 'Set' operation. Error: gen
Error".
Note - Connecting to an AT-9408LC/SP or to an AT-9424T/SP slave from any
master device that supports Enhanced Stacking can only be done once. Once the
management session is returned to the master device, any attempt to reconnect to
these slave devices will fail.
AT-9400 Series
AlliedView™-EMS 4.0.1 Device Management Guide Page 246 of 411