Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 45)

result, Device Manager will display integer values of '1' and '2' instead of the
value 'True' or 'False' for this parameter.
MSTP
Basic Info
Displays the basic information about Multiple Spanning Tree Protocol.
Instance Info
Displays information that contains Multiple Spanning Tree Protocol instance
specific information for the Multiple Spanning Tree Protocol.
Statistics
Displays statistics about frames received/transmitted on the switch port.
Basic Bridge Info
Displays basic bridge information.
Bridge Port Info
Displays statistics about frames received/transmitted on the switch port.
Note - The current firmware version does not allow the Number of Traffic Class
parameter to be configured. Attempting to configure this parameter to any valid
value will result in the error "The error occurred with 'Set' operation. Error. bad
value.".
802.1p
Device Capabilities
Displays information on the device capabilities.
Port Priority Group
Displays information about the port priority.
Traffic Class
Displays information about the traffic class and traffic class priority.
Note - Valid MIB Set values for the Received Traffic Class parameter is [0-7]
inclusive. However, the current firmware version does not allow this parameter to
be set to 4-7 as its value.
MAC Table Info
Displays MAC table information.
Note - The current firmware version does not allow Device Manager to handle
'TruthValues' for the Trap Enable parameter. As a result, Device Manager will display
integer values of '1' and '2' instead of the value 'True' or 'False' for this parameter.
MAC Base Priority Support
Displays MAC Base priority support.
AlliedView™-EMS 4.0.1 Device Management Guide Page 45 of 411