Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 149)

Bridge Menu
From the Bridge menu, you can view and edit bridge information such as the forwarding
database and the spanning tree status.
Forwarding Database
Note - Changes to the Forwarding Database table caused by dynamic network
topology/configuration changes will not be reflected unless the device is restarted.
Standard View
Displays the Forwarding Database table as returned by the device.
Enhanced View
Displays the Forwarding Database table on a per port basis. User can select a port
or group of ports to view its corresponding Forwarding Database entries.
Discard/Aging Time Info
Displays information about the number of address entries that were learned but
discarded because either there was a lack of memory or the entry's aging timer
expired.
Spanning Tree Info
Displays spanning tree parameters such as priority and cost.
Note - When the Spanning Tree Status parameter is set to 'enabled' and the Spanning
Tree Version parameter is set to 'mstp', the current firmware version continues to
return a value of 'forwarding' for the Port STP State parameter of blocking ports. As
a result, blocking ports will remain green and will not turn to yellow.
Statistics
Displays statistics about frames received/transmitted on the switch port.
RMON Menu
From the RMON menu you can view and edit the RMON MIB.
Statistics
Displays traffic statistics in the network segment attached to each port.
History Control Table
Displays the RMON History table.
Note - The current firmware version is unable to provide History Control Table
information. As a result, the following error message appears: "Failed to get MIB
data."
AlliedView™-EMS 4.0.1 Device Management Guide Page 149 of 411