Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 34)

Physical Description
Basic Info
Displays the number of stack units.
Module Info
Displays module information for each unit in the system.
Port Attributes
Displays port information.
Stack Info
Displays information about the stacked devices.
Stack Status
Displays the current unit ID and stack mode of the device after reset.
Note - The current firmware version does not allow Device Manager to
display the Current Unit ID parameter as a 'read-only' parameter for devices
configured in stacked mode.
Note - Valid MIB Set values for the Active Unit ID After Reset parameter is
[1-6] inclusive. However, the current firmware version allows the user to set
this parameter to '0'.
Power Supply Info
Displays information about the power supply.
Unit General Info
Displays the device's software versions.
Note - Configuring the Serial Number and Asset Tag parameters to any value
will cause the device to be inaccessible for approximately 1 minute.
Unit Environment Info
Displays the device's main power supply and temperature status.
Physical Sensors Info
Displays the device's sensor information.
Physical Entity
Displays the information about the device including the serial number.
Note - The current firmware version does not allow Device Manager to
display the Serial Number parameter as a 'read-only' parameter.
Note - Valid MIB Set values for the Physical Alias parameter should range
from 0 to 32. However, the current firmware version allows the user to
enter up to 6 characters only.
AlliedView™-EMS 4.0.1 Device Management Guide Page 34 of 411