Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 38)

LCLI Info
Displays information about the device's Telnet sessions and SSH sessions if
enabled or not.
Note - Valid MIB Set values for the History Size and SSH History Size
parameters should range from 10-206 and 10-210 respectively. However, the
current firmware version allows the user to enter values up to 246.
Note - Valid MIB Set values for the Telnet History Size parameter is [10-206]
inclusive. However, the current firmware version allows the user to enter
values up to 246.
RS-232
Displays the configuration of the baud rate of the device.
Web
Displays the configuration about the HTTP and HTTPS Port the device used.
Note - The current firmware version does not allow the following parameters to be
configured:
ƒ Idle Timeout
ƒ HTTP Port
ƒ HTTP Enable
ƒ HTTPS Port
ƒ HTTPS Enable
ƒ HTTPS Active Certificate ID
ƒ Max HTTP Idle Timeout
ƒ Service Protocol
Attempting to configure these parameters to any valid value will result in the
error "The error occurred with 'Set' operation.Error:gen Error.".
Note - The current firmware version does not allow the Service Port, Service
Certificate and Service Max Idle Timeout parameters to be set to '0', '1000'
and '932160' values respectively.
Note - Valid MIB Set values for the Service Certificate ID parameter is [0-
1000] inclusive. However, the current firmware version allows the user to
enter '-1' and '1001' as its value.
Date and Time
Time Synchronization
Displays the configuration about the device's date/time and time zone.
Note - Valid MIB Set values for the DST Offset parameter should range from 1-1440.
However, the current firmware version allows the user to enter values outside of
the valid range and negative values as well.
AlliedView™-EMS 4.0.1 Device Management Guide Page 38 of 411