Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 54)

Displays basic information about port lock.
Interfaces Range
Displays information about port lock interfaces range.
Note - The current firmware version does not allow Range parameter to be
configured. Moreover, attempting to configure this parameter followed by Refresh
operation will display numeric values.
MAC Control
MAC Control Sublayer
Displays information about the MAC Control sublayer on a single ethernet-like
interface.
Note - The current firmware version returns a 'noSuchName' value for Unknown
OpCodes Received and Unknown OpCodes Received (HC) parameters.
MAC Control PAUSE
Displays information about the MAC Control PAUSE function on a single ethernet-
like interface.
Note - The current firmware version returns a 'noSuchName' value for the Received
Frames (HC) and Transmit Frames (HC) parameters.
Note - The current firmware version does not allow the PAUSE Config parameter to
be set to 'enabledXmit' or 'enabledRcv' as its value.
Port Trunking
Basic Info
Displays basic information about port trunking.
Note - The current firmware version does not allow the Trunk Creation Support
and LACP Membership Restrictions Support parameters to be configured.
Balancing Criteria
Displays information about Aggregate Index.
Note - The current firmware version does not allow the Used Addresses and
Broadcast Type parameters to be configured.
Aggregator Info
Displays information about every Aggregator that is associated with this system.
Note - Valid MIB Set values for the Actor Administrative Key parameter is [1-65535]
inclusive.
AlliedView™-EMS 4.0.1 Device Management Guide Page 54 of 411