Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 35)

Note - Valid MIB Set values for the Physical Asset ID parameter should range
from 0 to 32. However, the current firmware version allows the user to
enter up to 16 characters only.
POE Info
MCU Info
Displays POE device's Microcontroller information.
POE Config
Displays POE device's configurations.
Note - AT-8000GS/24POE: When multiple units of the AT-8000GS series are
stacked together, the current firmware version does not allow the Maximum
PSE Power parameter to be configured to 'none' if the Unit ID of the device
is '3', '4', '5' or '6'.
Software Packages
Displays the device's software packages.
Management Info
General Management
Displays common management information.
Note - The current firmware does not allow the Reboot Delay parameter to be
configured.
Flash File System
Basic Info
Displays the flash file size of the device.
File List
Displays the device's list of files.
File Copy Info
Displays the device's file copy events.
Jumbo Frames
Displays the current jumbo frames status.
Management ACL
Basic Info
Displays basic information about the management access list.
Access Lists
Displays information about access lists.
AlliedView™-EMS 4.0.1 Device Management Guide Page 35 of 411