Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 137)

Errors
Displays information about errors related to the Frame Relay module.
Note - The Faults and Fault Time parameters are not applicable to the AT-AR700S
series and should be ignored.
DS1
DS1 Config
Displays DS1 configuration.
Note - The current firmware version returns a 'noSuchName' value for the Port
Number parameter.
Note - The following parameters are implemented as 'read-only':
ƒ Line Type
ƒ Line Coding
ƒ Send Code
ƒ Circuit ID
ƒ Loopback Config
ƒ Signal Mode
ƒ Transmit Clock Source
ƒ Facilities Data Link
ƒ Line Length
ƒ Change Status Trap
ƒ Channelization
Near-End
Current 15-Min Interval Statistics
Displays near-end DS1 statistics every 15 minutes.
Statistics for Past 24 Hours
Displays near-end DS1 statistics for the past 24 hours.
Cumulative Statistics
Displays accumulated near-end DS1 statistics.
Far-End
Current 15-Min Interval Statistics
Displays far-end DS1 statistics every 15 minutes.
Statistics for Past 24 Hours
Displays far-end DS1 statistics for the past 24 hours.
Cumulative Statistics
Displays accumulated far-end DS1 statistics.
AlliedView™-EMS 4.0.1 Device Management Guide Page 137 of 411