Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 385)

AT-CV1KSS
1000X to 1000X SFP
LED State Description
LT Green Link Test is enabled
SML Green Smart Missing Link is enabled
ML Green Missing Link is enabled
LCDS Green Line Card Dip Switch is enabled
Note - The current firmware version does not allow Device Manager to detect the presence
or absence of an SFP module in any of the SFP slots. As a result, the SFP slots on the device
image will always show SFP images regardless of whether or not SFP modules are physically
present in the slots.
Note - The SFP port images will always be fiber optic ports even if the actual SFP modules
inserted in the SFP slots have copper ports. This is because the current firmware version
does not allow Device Manager to identify the port type of SFP modules inserted in the SFP
slots.
Module Info
Note - The current firmware version does not return any value for the Module
Revision parameter.
Note - The current firmware version does not return the correct value for the
Module MAC Address parameter.
Note - AT-CV5M01: Configuring the Module Operation Mode parameter will result
in the error message: "The error occurred with 'Set' operation. Error: time out
occurred".
Port Info
Note - The current firmware version does not allow any of the parameters under
this table to be configured.
Converteon Series Modules
AlliedView™-EMS 4.0.1 Device Management Guide Page 385 of 411