Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 55)

Aggregator Port List
Displays Link Aggregation Control information for every Aggregation Port
associated with this device.
Aggregation Port Info
Displays a list of Link Aggregation Control configuration parameters for each
Aggregation Port on this device.
Note - The current firmware version does not allow the Actor Administrative Key
and Partner Administrative System ID parameters to be configured. Attempting to
configure these parameters to any valid value will result in the error "The error
occurred with 'Set' operation. Error. bad value.".
Note - Device Manager does not handle 8-bit string parameters correctly. As a
result, the Actor Administrative Status and Partner Administrative Status parameters
will display unrecognizable values and will not be configurable.
Storm Control
Basic Info
Displays basic information about storm control.
Storm Control Protection
Displays information about the storm control protection per port.
Note - The current firmware version does not allow the following parameters to be
configured:
ƒ Rate Type
ƒ Unknown Unicast Rate
ƒ Unknown Multicast Rate
ƒ Broadcast Rate
ƒ
Multicast Rate
Note - The current firmware version does not allow Device Manager to handle
'TruthValues' for the following parameters:
ƒ
Unknown Unicast Enable
ƒ Unknown Multicast Enable
ƒ Broadcast Enable
ƒ
Multicast Enable
ƒ Set Default Rate Type
ƒ Set Default Unknown Unicast Enable
ƒ Set Default Unknown Unicast Rate
ƒ Set Default Unknown Multicast Enable
ƒ Set Default Unknown Multicast Rate
ƒ Set Default Broadcast Enable
ƒ Set Default Broadcast Rate
AlliedView™-EMS 4.0.1 Device Management Guide Page 55 of 411