Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 383)

AlliedView™-EMS 4.0.1 Device Management Guide Page 383 of 411
LED State Description
LT Green Link Test is enabled
OAMB Green OAM Bypass is enabled
OAMV Green OAM Visible is enabled
LCDS Green Line Card Dip Switch is enabled
Note - The current firmware version will not al
port if the SFP port is set to disabled.
N
yet configured.
Note - AT-CV5M01: The current firmware version does not allow the Port Mode
low remote port connection on the RJ-45
ote - The Module Name parameter always displays 'yyyyyyyy' as its default value when not
rameter of FX type of ports to be configured. Attempting to configure this parameter
Port Mode value will result in the error message: "noSuchName."
emote
values, this parameter should not be
nfigured for the 100Base-FX port.
nfo
established link automatically changes to '10Mbps' and 'half duplex' when the value of
Note - The current firmware version does not allow Device Manager to configure or
rs of a port with an
established link automatically changes to '10Mbps' and 'half duplex' when the value of
- The current firmware version does not allow the Port Ingress Rate Limit and
ress Rate Limit parameters to be configured.
ontext
AT-CM70S will establish a Telnet session to the AT-CV5M01 management module.
pa
other than its current
R
Line Card Info
Note - Even if the current firmware version allows the Remote Port Mode
parameter to be configured to certain
co
Port I
Note - The value of the Port Speed and Port Duplex parameters of a port with an
its Port Mode parameter is changed from 'auto' to 'manual'.
display information on the T1/E1 port of the AT-CM70S.
Note - The value of the Port Speed and Port Duplex paramete
its Port Mode parameter is changed from 'auto' to 'manual'.
Note
Port Eg
C Menu
Note - Selecting the Telnet option in the RS-232 Terminal Port Context Menu of the