GW Instek APS-1102 User Manual - Manual (Page 88)

4.4 Using the Sequence Function
APS-1102 Programmable AC/DC Power Source 4-24
An example of basic step transitions is shown below.
Output parameters
Time
Normal output
step
Step 1 Step 2 Step 3
Steps 1, 2
Step 3
Figure 4-5. Example of Basic Step Transitions
c) Sequence mode
Figure 4-6 shows a mode transition diagram for sequence operations.
Idle mode
(normal output)
Output on
Run mode
(sequence
execution) Hold mode
(pause)
Figure 4-6. Block Diagram of Sequence Mode Transitions
Modes also change according to the [step end] specification.
Table 4-6. Sequence Modes
Idle mode Mode during normal output.
Run mode Mode during sequence execution.
Hold mode
Sequence pause mode.
Maintains output at time when was set.
！
CAUTION