GW Instek APS-1102 User Manual - Manual (Page 27)

2.3 Grounding and Power Supply Connection
APS-1102 Programmable AC/DC Power Source 2-7
 Connect the power in this order.
1. Make sure that the power source voltage to be used is within the specified range.
2. Set the power switch to off.
3. Insert the power cord into the inlet on the rear panel.
Inlet
Figure 2-2. Power Source Inlet
4. Insert the power cord plug into a 3-prong power source outlet (use the supplied power source cord
set 1).
The accompanying power cord set 1 (Japan version) complies with Japan Electrical Appliance and
Material Safety Law and is for use in Japan only. The rated voltage is 125 V AC and the withstand
voltage is 1250 V AC. This power cord set cannot be used when the voltage exceeds 125 V AC or in
locations outside of Japan.
The accompanying power cord set 2 is intended for use in Japan, North America, and Europe. The
rated voltage is 250 V AC and the withstand voltage is 2000 V AC. Attach a plug or crimp contact
that suits the use environment. When using this cord set in Japan, be sure to use a plug that complies
with Japan Electrical Appliance and Material Safety Law.
The accompanying power cord sets are for use with this product only. Do not use them with other
products or application systems.
The product itself has a withstand voltage of 1500 V AC.
！
CAUTION
！
CAUTION
！
CAUTION