GW Instek APS-1102 User Manual - Manual (Page 144)

5.3 SET Menu
APS-1102 Programmable AC/DC Power Source 5-18
5.3.3 Setting output voltage
The output voltage settings listed below can be made for the two operation modes.
Table 5-13. Output Voltage Settings
Operation Mode Setting Setting Range Resolution
AC mode
(AC-INT,
AC-ADD,
AC-SYNC)
AC
voltage
100 V range
0.0 to 140.0 Vrms 0.1 Vrms
0.0 to 400.0 Vp-p 0.1 Vp-p
200 V range
0.0 to 280.0 Vrms 0.1 Vrms
0.0 to 800.0 Vp-p 0.1 Vp-p
AC+DC mode
(AC+DC-INT,
AC+DC-ADD,
AC+DC-SYNC)
DC
voltage 100 V range 200.0 to +200.0 V 0.1 V
200 V range 400.0 to +400.0 V 0.1 V
AC
voltage
100 V range
0.0 to 140.0 Vrms 0.1 Vrms
0.0 to 400.0 Vp-p 0.1 Vp-p
200 V range
0.0 to 280.0 Vrms 0.1 Vrms
0.0 to 800.0 Vp-p 0.1 Vp-p
When the selected AC voltage waveform is either SIN (sine wave) or SQU (square wave), the AC voltage
setting is made in Vrms units. When it is ARB (arbitrary waveform) 1 to 16, this setting is made in Vp-p
units.
 Operation steps
Select either
“AC voltage” or “DC voltage” in the output voltage SET menu then set a
numerical value.
See “3.4.5 Setting output voltage”, for description of output voltage setting.
See also “4.1.4 Setting the output voltage”.