GW Instek APS-1102 User Manual - Manual (Page 109)

4.4 Using the Sequence Function
APS-1102 Programmable AC/DC Power Source 4-45
8. Press the key to select “CONTROL”, then press the
ENTER
key to display the selection box.
ENTER CANCEL
9. Select “START”, then press the
ENTER
key to start the sequence.
b) When using keys on the control panel
 Operation steps
1. Press the TOP MENU key to return to the top menu, check the settings in the menu, then press the
OUTPUT
key on the control panel.
 This set output on, at which time the output on/off LED goes on.
OUTPUT OUTPUT
Output off Output on
2. Press the START key (shortcut key) to start sequence.
SEQUENCE
STOP START
TOP
MENU LOCAL HOLD
Selection box
Output on/off LED is on