GW Instek APS-1102 User Manual - Manual (Page 252)

9.1 Output
APS-1102 Programmable AC/DC Power Source 9-4
 Maximum output peak current
100 V range: 40 Apk
200 V range: 20 Apk
Note 1: For the AC 100 V input system, the limit on the maximum output power may cause a
reduction in the maximum output peak current.
Note 2: The above values are for a capacitor input type rectifier circuit whose crest factor is 4 or
less.
Note 3: At or above the rated output voltage, the limit on the maximum output power may reduce
the maximum output peak current.
Note 4: When output frequency is 40 Hz or lower, or it is 400 Hz or higher, the maximum output
peak current may decrease.
Note 5: The peak value of AC + DC is within the maximum output peak current.
 Frequency setting range
(When signal source mode is internal or internal + external mode only)
Setting range:
1.0 Hz to 550.0 Hz
Setting resolution: 0.1 Hz
Setting accuracy: ±100 ppm (1.0 Hz to 550.0 Hz, 23 ±5°C)
 Phase when output is on
(When signal source mode is internal or internal + external mode only)
Setting range:
0.0  to 359.9
Setting resolution: 0.1 
 Output voltage waveform
(When signal source mode is internal or internal + external mode only)
Sine wave, square wave, arbitrary waveform (16 types)
 Small amplitude frequency response
(When signal source mode is internal, 100 V range, output voltage is 20 Vrms, 50 Hz rating)
AC mode
40 Hz to 100 Hz: ±0.5 dB
100 Hz to 550 Hz: +1 dB, 3 dB
AC+DC mode DC to 100 Hz: ±0.5 dB
100 Hz to 550 Hz: +1 dB, 3 dB
 Output voltage distortion factor
0.5% or less (50 Hz or 60 Hz)
 Load regulation
0.5% or less (0 to 100%, via output terminal)