GW Instek APS-1102 User Manual - Manual (Page 115)

4.7 Synchronization of Output to External Signal
APS-1102 Programmable AC/DC Power Source 4-51
4.7.1 External signal synchronization
This function synchronizes the output frequency to a signal that is input to the rear panel external sync
signal input (BNC connector). The output frequency can be synchronized to any frequency from 40 to
500 Hz.
 Operation steps
Select
in the SET menu to select external synchronization mode, then set the sync signal source
to external sync signal “EXT”.
1. Make sure that output is off. When output on, line synchronization cannot be switched off or on.
OUTPUT OUTPUT
Output on Output off
2. Press the or key to move the cursor to the icon.
ENTER CANCEL
Cursor
3. Press the
ENTER
key to display the selection box, then press the or key to move the
cursor to “AC-SYNC” or “AC+DC-SYNC”.
ENTER CANCEL