GW Instek APS-1102 User Manual - Manual (Page 122)

4.9 Amplification of External Signal
APS-1102 Programmable AC/DC Power Source 4-58
a) Possible voltage settings for output
 Operation steps
Select the icon in the SET menu corresponding to the desired setting, then set a numerical value.

“Select output mode”: Select external mode (AC-EXT or AC+DC-EXT).
 “Output voltage range”: Select 100 V or 200 V.
 “Set external input gain”: Set a numerical value.
1. Press the or key to move the cursor to he icon, then press the
ENTER
key.
 The selection box is displayed.
ENTER CANCEL
2. Press the or key to move the cursor to the mode to be set, then press the
ENTER
key.
 This sets the selected output mode.
ENTER CANCEL
3. Press the or key to move the cursor to the icon, then press the
ENTER
key.
 The selection box is displayed.
ENTER CANCEL
4. Press the or key to move the cursor to the output voltage range to be set, then press
Selection box
Selection box