GW Instek APS-1102 User Manual - Manual (Page 195)

6.3 Command Descriptions
APS-1102 Programmable AC/DC Power Source 6-23
 [SOURce:]VOLTage:LIMit:LOW
This sets the upper limit of the output voltage that can be set. However, a value that is at or below
the currently set cannot be specified. ([5, “Out of Limiter”] error occurs.)
For the 100 V range, the limit value setting ranges from
200.0 to 5.0 V, and for the 200 V range,
it ranges from 400.0 to 10.0 V.
Syntax: [SOURce:]VOLTage:LIMit:LOW
Parameters: 200.0 to 5.0 (400.0 to 10.0)
Command example: VOLT:LIM:LOW 200
Query example: VOLT:LIM:LOW?
Response format:
Response example: 200.0
 [SOURce:]VOLTage:OFFSet[:IMMediate]
This sets the DC voltage when in AC+DC-INT, AC+DC-ADD, or AC+DC-SYNC mode. For the
100 V range, the DC output voltage setting ranges from
200.0 to 200.0 V, and for the 200 V range,
it range, from 400.0 to 400.0 V.
The DC output voltage cannot be set unless the mode is AC+DC-INT, AC+DC-ADD, or
AC+DC-SYNC mode. ([3, “Invalid in this mode”] error occurs.)
Syntax: [SOURce:]VOLTage:OFFSet[:IMMediate]
Parameters: 200.0 to 200.0 (400.0 to 400.0)
Command example: VOLT:OFFS 10
Query example: VOLT:OFFS?
Response format:
Response example: 10.0
 [SOURce:]VOLTage:RANGe
This sets the output voltage range. The output voltage range setting is 100 V or 200 V.
However, when output is on, output voltage range cannot be changed. ([1, “Invalid with output
on”] error occurs.)
Syntax: [SOURce:]VOLTage:RANGe
Parameters: 100/200
Command example: VOLT:RANG 100
Query example: VOLT:RANG?
Response format:
Response example: 100